Please install the product following the method below.
1. Installing the electrostatic sticker.
Clean your windshield and put the electrostatic sticker on the recommended area as shown in the figure below. Avoid the edge of the windshield and select the flat and smooth area for the installation.
Make sure you remove air bubbles between the sticker and the glass.
2. Installing the memory card.
Insert the memory card into the card slot with its contacts facing up until you hear a click. The memory card is well-installed.

3. Installing the mount.
Attach the mount into the slot and slide up, as shown in the figure below. You will hear a snap when it is in place. Make sure the mount is securely installed to the dash cam.

4. Mounting the dash cam.
Peel off the protective film from the adhesive sticker on the base of the mount, and paste the dash cam onto the electrostatic sticker in the dotted area.

5. Connecting the power supply.
As shown in the figure below, run the power cord along the top of the windshield, down the A-pillar, and around the glove compartment, so that the power connector is near the cigarette lighter. Connect the power cord to the car charger, then plug the charger into the cigarette lighter socket.
Notes:

• Use the included crowbar to hide the power cord underneath the vehicle’s headliner and rubber seal along the A-pillar.
• Depending on the vehicle, the cigarette lighter socket may be located in a different position. The above figure is for reference only.

6. Adjusting the dash cam angle.
Turn on the dash cam and adjust the camera angle based on the preview screen to ensure that the camera is facing the front of the vehicle.