Installation

Step 1: Testing video signal

  1. Turn off the car engine and power.
  2. Insert connector A into connector B, so that the backup camera is connected with the video signal wire.
  3. Connect the red wire from the backup signal wire to the positive pole of the car ’s reverse light power cable.
  4. Insert the power connector into the AV/IN port of the main device.
  5. Ensure that the environment is safe, start the car, shift into reverse gear, and observe whether the screen of the main device displays the backup image.

If the backup image is not displayed, please check the wire connection first. If the wire connection is correct but the backup image still cannot be displayed, please contact after-sales service personnel.

Step 2: Routing wire

  1. Turn off the car engine and power.
  2. Insert the power connector into the AV/IN port of the main device, and then route the wire along the car body to the rear trunk lid.
  3. Connect the red wire from the backup signal wire to the positive pole of the car’s reverse light power cable, and secure the black wire with insulating adhesive.
  4. Disconnect the connection between the backup camera and the video signal wire.

Step 3: Installing the backup camera

  1. Place the backup camera in the intended installation position. Remove the protective film on the back of the mount and stick the camera onto the car body.
  2. Drill two screw holes and one lead wire hole at the installation position.
  3. Thread the lead wire through the hole and connect it to the video signal wire.
  4. Secure the backup camera at the installation position using screws.

Step 4: Adjusting the backup camera angle

  1. Remove the protective film on the surface of the backup camera.
  2. Adjust the angle of the backup camera up and down to ensure that it is parallel to the ground. As shown in the figures:

Before

After

Notes:

  • The installation and wiring methods may vary from the user manual for different vehicles. Please have the installation performed by a professional installer.
  • Before installation and wiring, please turn off the car engine and switch off the car power to avoid short circuit during operation.