1. Installing the electrostatic sticker
Paste the electrostatic sticker on the recommended area on the front windshield. Press the sticker to remove air bubbles out.
Avoid the edge of the windshield and select the flat and smooth area for the installation.
Note: Keep windshield clean and dry without liquid residue to prevent the sticker from losing adhesion and dash cam from dropping.
2. Installing the memory card
Insert the memory card into the card slot.
3. Mounting the dash cam
Paste the dash cam onto the electrostatic sticker.
Notes:
- The dash cam is pre-installed on the bracket when it leaves the factory. To remove the dash cam, hold and rotate it until icon
aligns with icon 
on the bracket, then pull it out to detach the dash cam. - To install the dash cam, insert it into the bracket and rotate it until icon and icon on the bracket are misaligned.
- The dash cam is pre-installed on the bracket when it leaves the factory. To remove the dash cam, hold and rotate it until icon
4. Routing cable
Route the power cord to the cigarette lighter and connect to power.
Note: Depending on the vehicle, the cigarette lighter socket may be located in a different position. The above figure is for reference only.
5. Adjusting the camera angle
Bind the dash cam to the 70mai app. Adjust the camera angle based on the image presented in the dash cam’s homepage.
