Install the receiver

Remove the film on the adhesive and attach the receiver in the direct view of the driver.

 

Install the sensor

1. Remove the four tires separately. Deflate them and remove the original tire nozzle. (When removing the tires, pay attention to their original location so that they can be put back to their original position. After removing the nozzles, clean the nozzle hole on the wheel hubs with detergent.)

2. Remove the dust cap and tightening nut of the sensors.

3. Install the sensors to the nozzle hole of the wheel hubs according to the sensors’ serial number. (Ensure that the electronic module of the sensors is parallel to the wheel hub to maintain continuous operation and accuracy.) Secure the sensors to the nozzles using the tightening nuts.
Note: The torque of the tightening nut should be 3-5 N • m.

4. Fix the tires to the wheel hubs and inflate the tires to the standard pressure.

Tips: Turn on the receiver before installing the sensors.
While inflating the tires, the receiver will display the tire pressure and temperature based on the data it receives from the sensors. If the receiver does not display the tire pressure and temperature, do not install the tires. Contact the After-sales Service Department for assistance.

5. Check the tire nozzles for leakage. (If there is any leakage, adjust the nozzle angle or clean the nozzle hole on the wheel hub.)

6. Calibrate the tires through dynamic balancing.

7. Install the tires back to their original location.

8. Paste the tire pressure warning stickers so that it points at the nozzle of the wheel hub.